Errors; Switching Protocol; Command Types Or Modes - NeoPro DOC42 Integrator Manual

Errors

Any command with invalid parameters or a syntax error will result in a response
of:
[E]

Switching Protocol

Note: Some NeoPro matrix switch models do not have all these features and
will display the error [E] response when such a command is received. Refer to
the Model Specific Features section for details.
Switching commands use this structure
[mc,i,o,t]
m
is the first letter of the model name (refer to Model Specific Features section)
c
is the Command Type or Mode
i
depends on the Command Type:
For switching
output zone. For
value from 0-99.
o
is the Output number (0 to maximum number of outputs). Output
selected input to all output zones (Party Mode).
t
is time in seconds
Optional for delays and fades, ignored in

Command Types or Modes

X
switches All A/V Signals
V
switches High Definition Video (YPbPr)
D
switches Digital Audio (SPDIF)
A
switches Analog Audio (L/R stereo)
C
switches Composite Video
L
sets the Volume Level
B
sets the Bass Level (
Greater values for boost and less than 50 to attenuate.
T
sets the Treble Level (
Greater values for boost and less than 50 to attenuate.
i
is the Input number. Input 0 will disable the selected
L B T
, , and
i
values from 0 to 99). Flat response = 50.
i
values from 0 to 99). Flat response = 50.
DOC42-00027-C Integrator's Guide.doc
(Volume, Bass, Treble commands)
B
&
19
0
sends the
T
Commands.
i
is a