Remove Fans; Fig. 9 - Power Board; Fig. 10 - Exposed Power Board; Fig. 11 - External Fan Thermostat - Norcold 2118 Manual

Disassemble, cont'd.
B
WARNING : High voltage can cause servere injury
and death. ONLY qualified RV service techincians
are autorized to remove this cover. Do not allow leak detecting
solutions to touch the electrical components. Many liquids are
electrically conductive and can cause a shock hazard, electical
shorts, and in some cases fire.
CAUTION: 12VDC supply connections are for low
voltage direct current only. DO NOT connect 120 or
240 VAC.
MISE EN GARDE : Le courant à haute tension peut
causer des blessures graves et la mort. SEULS les
techniciens agréés pour véhicules de plaisance sont
autorisés à ôter ce couvercle Ne pas laisser la solution de
détection des fuites entrer en contact avec les composants
électriques. Beaucoup de liquides son conducters
d'électricite et peuvent préseter des danger d'électrucution,
de courts-circuits et parfois d'incendie
ATTENTION : les raccords à courant 12 V c.c. sont
prévus exclusivement pour le courant continu à basse
tension. NE PAS le brancher au courant à 120 ou 240 V c.c.

Fig. 9 - Power Board

A. Power board
B. Cover screws
C. Igniter wire
D. Heater wires
Caution!
Pull gently when disconnecting igniter wire.
!
Failure to comply can cause permanent damage to power
board.
2. Carefully remove connector of igniter wire (Fig.9.C) from power
board (Fig.10,A). Do not pull directly on wire.
A
P2
D

Fig. 10 - Exposed Power Board

3. Remove power board cover screws (Fig.9,B) (2x); remove cover.
4. Disconnect heater wires (Fig.10,D) at the power board.
• AC_HT_LO (Black) - Heater 1
• AC_HT_LO_2 (Black) - Heater 2
• AC_HT_HI (Black) - Heater 1
• AC_HT_HI_2 (Black) - Heater 2
Note:
Heaters are contained in canister located on back
right side of refrigerator.
www.norcold.com
C
100 B
ANSI Z21. 2
9
4
8
5
3
M
3
3
N 4
07 07
7
C 1
5VDC
c
0544
700514
4 05-43
5A@120VAC
CHINA
CPC - E
94 V - 0
P3
P1

Remove Fans

2.8 2.8
B

Fig. 11 - External Fan Thermostat

A. External Fan thermostat
B. Thermostat screws
C. Condenser
D. Fans
E. Fan screws

Fig. 12 - Fan Mounting

1. Remove fan thermostat screws (Fig.11,B) (2x); remove thermostat
(Fig.11,A). Save all parts.
Note:
Disconnecting wires from thermostatic switch not
required.
2. On back of refrigerator, remove mounting screws (Fig.12,E) (4x)
from the two (2) upper fans and the lower fan; remove fans and lay
to left side of refrigerator. Do not unplug fan wiring.
3. Cut the cable tie holding the wiring and the icemaker waterline so
that the fans and wiring can be positioned on the left side of the
refrigerator out of the way.
7
C
A
B
D
E