Table of Contents
Advertisement
Mounting the antenna (Fig. 6)
Install the mast according to the instructions of the mast manuf-
acturer. For installation in caravans or mobile homes, the Sat join-
ted mast HDM 140 can be used. For installation on a truck, use
the HDM 141.
If you wish to convert your terrestrial reception system composed
of the HD 35 and the Shapeg mast HDM 135 to a satellite recepti-
on system, please use the jointed mast HDM 143.
The roof duct and fixing console of the HDM 135 can continue to
be used.
These masts allow an easy and quick alignment of the antenna
from the interior of the vehicle.
Detailed mounting instructions are supplied with the mast.
When mounting the mast, proceed as follows:
1. Prepare the mast swivel head as shown in Fig. 6
2. Slide the antenna into the swivel head as far as possible
3. Fasten the antenna with the clamp; torque for the two M 6
screws: M = 6.5 + 1 Nm
Connecting the cable
Connecting the cable to the antenna (Fig. 7)
1. Loosen the two knurled screws and remove the LNB cover.
2. Connect the F-type plugs as shown.
3. Connect the cables to the LNB.
4. Now press the cables (outer diameter 6.8 mm) into the ca-
ble support. If you use the thinner cables (e.g. for Sat jointed
masts HDM xxx with integrated cables), first put the supplied
sleeves on the cables in order to compensate the diameter.
5. Re-fit the LNB cover.
Fig. 6
2 x Braiding folded back
5 / 12
freie Kabellänge
ca. 600 mm
Optional spring washer
Fig. 7
Advertisement
Table of Contents
