Viewing The System Status; Selecting The Power-On Mode; Selecting The Demo Mode - Toshiba 42XV540U Owner's Manual

Viewing the system status

To view the system status:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the System Status menu, highlight System
Information, and press T.
3
Press C c to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the System Status menu, highlight System
Information, and press T.
3
Press C c to scroll through the menu bar to select
Factory Defaults.
4
Enter your PIN code (or 0000 if no PIN code has been set).
Highlight Yes and press T. The TV will turn off
5
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
To cancel the reset:
Highlight No and press T.
40
Chapter 5: Setting up your TV

Selecting the Power-On Mode

You can select either Power-Saving or Fast mode.
Power-Saving mode keeps power consumption in standby
•
mode to below 3W. As a result, it takes a bit longer for the
TV to turn on.
Fast mode increases power consumption in standby mode.
•
As a result, the TV will turn on more quickly. While in Fast
mode, the yellow LED on the front of the TV will be lit.
To set the Power-On Mode feature:
1
From the Setup menu, highlight Power-On Mode and
press c.
2
Press B or b to select either Power-Saving or Fast, and
press T.
To return to normal viewing:
Press O.

Selecting the Demo Mode

You can set the TV's demo mode to On or Off.
This feature is provided for demonstrational purposes only.
To select the Demo Mode:
Press Y, and open the Setup menu.
1
2
Highlight Demo Mode and press c.
Press B or b to select either On or Off, and press T.
3
Note: If the demo mode has been set to On, the Demo mode
will run automatically when you turn on the TV.