Using the FREEZE feature
To use the FREEZE feature:
When viewing the TV, press B to make the picture a
1
still picture.
To return to the moving picture, press B again.
2
Note: If the TV is left in FREEZE mode for more than 15
minutes, the FREEZE mode will automatically be released
and the TV will return to moving picture.
Using the FREEZE function for any purpose other than your
private viewing may be prohibited under the Copyright Laws
of the United States and other countries, and may subject
you to civil and criminal liability.
Adjusting the picture
Selecting the picture mode
You can select your desired picture settings from the following
modes, as described below.
Mode
Picture Quality
Sports
Bright and dynamic picture
Standard
Standard picture settings
Movie
Lower contrast for darkened room
Designed for viewing of PC tables and
PC
documents
Preference
Your personal preferences
Note: PC mode is available for HDMI and PC inputs only
(grayed out for other inputs).
From the Video menu, highlight Mode and press T.
1
2
Press B or b to select the picture mode you prefer and
press T.
Note: The picture mode affects the current input only.
48
Chapter 6: Using the TV's features
Adjusting the picture quality
You can adjust the picture quality (Contrast, Backlight,
DynaLight™, Brightness, Color, Tint, and Sharpness) to your
personal preferences.
Selection
Contrast
Backlight*
DynaLight**
Brightness
Color
Tint
Sharpness
* Backlight
This feature adjusts the brightness of the entire screen. When in
video mode and no signal is input, this will automatically be set to 0.
(Settings are stored in memory.)
**DynaLight
This function automatically strengthens the black coloring of dark
areas in the video according to the level of darkness.
To adjust the picture quality:
1
From the Video menu, highlight Picture Settings and
press T.
2
Press B or b to select the picture quality you want to
adjust (Contrast, Backlight, DynaLight,
Brightness, Color, Tint, or Sharpness), and then
press C or c to adjust the setting, as described in the table
above.
To save the new settings, highlight Done and press T.
3
You can use any of the picture modes (- "Selecting the
picture mode," above left) as a starting point for adjusting
the picture settings.
To revert back to the base mode that you began adjusting
the picture settings from, highlight Reset and press T.
The picture qualities you adjusted are automatically saved in
the Preference mode (- "Selecting the picture mode,"
above left) until Reset is selected.
Pressing C
Pressing c
lower
higher
darker
lighter
On/Off
On/Off
darker
lighter
paler
deeper
reddish
greenish
softer
sharper