Connecting A Vcr And Satellite Receiver; Black - Toshiba 42HP95 Owner's Manual

Connecting a VCR and satellite receiver

You will need:
one signal splitter
four coaxial cables
one set of component video cables (if your satellite receiver
does not have component video, connect the standard A/V
cables only)
one pair of standard audio cables
three sets of standard A/V cables
• For better picture performance, if your satellite receiver and VCR
have S-video, connect S-video cables (plus the audio cables)
instead of the standard video cables. Do not connect both types of
video cables to VIDEO 1 (or VIDEO 2) at the same time or the
picture performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV (VIDEO 1)
to your VCR's audio out terminal using the white audio cable only.
To view satellite programs using the component video
connections:
Select the ColorStream HD-1 video input source on the
TV.*
To view satellite programs using the standard
video connections or to record satellite programs:
Turn on all three devices. Set the VCR to the appropriate
line input (refer to your VCR owner's manual for details).
Select the VIDEO 2 video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Tune the VCR to the channel you want
to watch. Select the VIDEO 1 video input source on the
TV.*
_____________
*
To select the video input source, press INPUT on the remote control
(see page 69). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
16
#01E_013-027_4250HP95 16

Black

(E) 42/50HP95 *web 213:276
Chapter 2: Connecting your TV
TV back panel
From satellite dish
Satellite
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate
input mode is selected.
To use the TV Guide On Screen
1. Connect the G-LINK
instructions on page 26.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owner's manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen
5. See Chapter 7 for details on using the TV Guide
On Screen
Note: The TV Guide On Screen™ system does not receive program
listings from or for any satellite service.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
From antenna
IN
Signal splitter
OUT OUT
Stereo VCR
VIDEO AUDIO
IN from ANT L
CH 3
CH 4
OUT to TV
L
Satellite receiver
AUDIO
L
Y P P
B R
IN
R
S-VIDEO COMPONENT VIDEO VIDEO
OUT OUT
™
recording features:
™ cable according to the
™ system.
™ system.
05.9.12, 10:05 PM
R
IN
OUT
R
OUT
L
R