HP ProLiant DL360p G8 Maintaining And Troubleshooting page 28

Maintaining and Troubleshooting the HP DL360p G8 Server
7. Remove the PCIe riser board.
a. Remove screws (#1 in following images)
b. Remove board (#2 in following images)
Note:
The x16 PCIe riser board has two screws to remove from the assembly and the x8 PCIe
riser board has three screws to remove from the assembly.
Figure 6: Right side, expansion slot 2 PCIe x16, half-height half-length
Figure 7: Left side, expansion slot 1 PCIe x8, low profile
8. To replace the component, reverse the removal procedure.
Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server
28
Comments on this document? infodev@avaya.com
September 2013