Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba 42HP83 Owner's Manual

Adding channels to the TV's memory

When you press Channel y or z, your TV will stop only on the
channels you program into the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and
store them into its memory. After the channels are programmed
automatically, you can manually add or erase individual channels (see
page 31).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
SET UP
LANGUAGE ENGL SH
ANT 1 / 2 ANT 1
TV / CABLE TV /
CH PROGRAM
ADD / ERASE ADD
QUICK CONNECT GUIDE
4. Press z to select CH PROGRAM.
SET UP
LANGUAGE ENGL SH
ANT 1 / 2 ANT 1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD
QUICK CONNECT GUIDE
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel y or z to view the programmed channels.
30
I
CABLE
I
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
POWER
TV
LIGHT SLEEP
CABLE/SAT
VCR
1 2 3
DVD
Channel
AUDIO1
AUDIO2 4 5 6
Number
MODE
7 8 9
PIC SIZE
+10
0
100/
ENT
ACTION
MENU
MENU
FAV
ENTER
yzx •
FAV
Channel yz
VOL
CH
EXIT
DVD CLEAR
DVD RTN
CH RTN INPUT RECALL MUTE
SLOW/DIR SKIP/SEARCH