Setting The Auto Input Feature - Toshiba Regza 42HL167 Owner's Manual

To add a channel to the channel memory:
Highlight the unchecked box next to the channel number you
want to add, and then press T to check the box.
To manually add digital subchannels on a physical
channel:
Use the Channel Numbers and the Dash (=) on the remote
control to enter the channel number (for example, 56–1).
If the channel is found, the number will be added to the list and
the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press T to uncheck the box.
To save your new settings:
Highlight Done and press T.
To revert to your original settings:
Highlight Cancel and press T before saving.
To remove all channels from the channel memory:
Highlight Reset and press T, and then highlight Done and
press T.
Channel Add/Delete
2
2 - 1
2 - 2
3
4
5
6
7
7 - 1
8
To remove encrypted channels from the channel
memory:
If an encrypted channel is accidentally added to the channel list
by programming channels, you can remove the unwanted
encrypted (non-viewable) channel while you are channel
surfing. When you tunes to an encrypted channel, the
following message will appear.
Digital Channel Is Encrypted - Press 1 on remote to remove channel
Press "1" button while the message is on the screen to
remove the unnecessary channel from the channel list.
Chapter 5: Setting up your TV
Analog
Digital
Digital
Analog
Analog
Digital
Analog
Analog
Reset
Digital
Cancel
Analog Done

Setting the Auto Input feature

This feature allows you to change TV inputs using the mode
select buttons—TV, CABLE/SAT, DVD, VCR/PVR—on
the remote control. Once an input has been set for a specific
mode select button, the TV will automatically switch to that
input when that mode select button is pressed.
Auto Input settings options for each mode select button are
shown below.
TV: ANT
•
CABLE/SAT: ANT, Video 1, Video 2, ColorStream HD1,
•
ColorStream HD2, HDMI 1, HDMI 2, HDMI 3, PC
DVD: Video 1, Video 2, ColorStream HD1,
•
ColorStream HD2, HDMI 1, HDMI 2, HDMI 3, PC
VCR/PVR: ANT, Video 1, Video 2, ColorStream HD1,
•
ColorStream HD2, HDMI 1, HDMI 2, HDMI 3, PC
Note: The TV mode select button will be restricted to the ANT
input.
To set the Auto Input:
Press Y and open the Preferences menu.
1
Highlight Auto Input and press T.
2
Preferences
CC Selector
Base CC Mode
Digital CC Settings
Auto Input
Input Labeling
Channel Labeling
Menu Language
Channel Browser Setup
3
Press B or b to highlight Enable Auto Input and then
press C or c to select On.
Auto Input
Use this menu to enable your TV's automatic input switching feature when
changing modes on your remote control.
Enable Auto Input
POWER
TV
SLEEP
CABLE/SAT
TV DVD
MODE SELECT
CABLE/SAT DVD VCR/PVR
VCR/PVR
Reset
Off
English
On
- -
ColorStream HD1
HDMI 1
Video 1
Done
(continued)
41