Viewing The System Status; Selecting The Blue Led Illumination Level; Selecting The Power-On Mode; Selecting The Demo Mode - Toshiba 2XF550U Owner's Manual

Viewing the system status

To view the system status:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the System Status menu, highlight System
Information, and press T.
3
Press C c to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the System Status menu, highlight System
Information, and press T.
3
Press C c to scroll through the menu bar to select
Factory Defaults.
4
Enter your PIN code (or 0000 if no PIN code has been set).
Highlight Yes and press T. The TV will turn off
5
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
To cancel the reset:
Highlight No and press T.
40
Chapter 5: Setting up your TV
Selecting the Blue LED Illumination
level
You can adjust the brightness of the blue LED located on the
front panel (the options are High, Middle, and Low).
To set the Blue LED Illumination level:
Press Y, and open the Setup menu.
1
2
Highlight Blue LED Illumination and press c.
3
Press B or b to select your desired illumination level, and
press T.

Selecting the Power-On Mode

You can select either Power-Saving or Fast mode.
Power-Saving mode keeps power consumption in standby
•
mode to below 3W. As a result, it takes a bit longer for the
TV to turn on.
Fast mode increases power consumption in standby mode.
•
As a result, the TV will turn on more quickly. While in Fast
mode, the yellow LED on the front of the TV will be lit.
To set the Power-On Mode feature:
1
From the Setup menu, highlight Power-On Mode and
press c.
2
Press B or b to select either Power-Saving or Fast, and
press T.
To return to normal viewing:
Press O.

Selecting the Demo Mode

You can set the TV's demo mode to On or Off.
This feature is provided for demonstrational purposes only.
To select the Demo Mode:
Press Y, and open the Setup menu.
1
2
Highlight Demo Mode and press c.
Press B or b to select either On or Off, and press T.
3
Note: If the demo mode has been set to On, the Demo mode
will run automatically when you turn on the TV.