Makita UH6570 Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Lifter section
DISASSEMBLING
Refer to the clause of [3]-2.
ASSEMBLING
Refer to Fig. 14.
Three plates X, Y and Z of Lifter have to be linked with each appropriate portion in the following order.
1. Plate X is fit into the U groove of Pusher cap.
2. Plate Y is put on the hook portion of Lever.
3. Plate Z is fit into the groove of Switch lever A.
Set the components in place while pay attention to the linked portions illustrated in Fig. 14.
Fig. 14
Z
Switch lever A
Switch lever C
X
Y
Z
X
Link
Rod
Gear housing complete
Cap
holder
Lifter
Pin
holder
Y
Lever
P 5/ 7
Insulation cap
Compression
spring 8
Pin 5 (to the hole of
Gear housing complete
through Cap holder,
Lifter and Pin holder)
Pusher cap
Rod 3 (for pushing
Link)