Delta DJ-20 Series Instruction Manual page 17

FENCE OPERATION
The fence can be moved across the table by loosening
lock lever (A) Fig. 30, move the fence to the desired
position, and tighten lock lever (A) securely. As the fence
is moved across the table, the sliding portion of the
fence bracket (F) guards the cutterhead in back of the
fence as shown.
To tilt the fence to the right or left, loosen handle (B)
Fig. 31, pull out plunger (C) and using the fence tilting
lever (D), move the fence to the desired angle and
tighten handle (B) securely. NOTE: The handle (B) Fig.
31, is spring-loaded and can be repositioned by pulling
out the handle and repositioning it on the serrated nut
located underneath the handle. IMPORTANT: When
cutting a bevel, we suggest that whenever possible the
fence be tilted toward the table, as shown in Fig. 32. The
fence will then form a V-shape with the tables, and the
work is easily pressed into the pocket while passing it
across the knives.
ADJUSTING FENCE
POSITIVE STOPS
The fence on your jointer is equipped with positive stops
at the most used fence positions of 90 degrees and 45
degrees right and left. To check and adjust the positive
stops, proceed as follows:
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
1. Position the fence 90 degrees to the table by making
sure end of plunger (A) Fig. 33, is engaged in notch
in index collar (B), as shown, and tighten lockhandle
(C).
A
17
A
F
Fig. 30
B
C
D
Fig. 31
Fig. 32
E
C
Fig. 33
B