Advertisement
Step Two
Attach Front Gussets to Extension
Position the remaining Gussets on each side of
the 5/16" hole that is near the middle of the
Extension. The small flange on the Gusset that is
next to the round hole should lie on top of the
Extension. The flange that runs the length of the
Gusset should point towards receiver end of the
Extension which has the large hitch pin hole in it.
Attach both Gussets to the Extension using one 5/
16 x 3 Hex Bolt, Lock Washer, Hex Nut and two
Backing Plates. The Backing Plates should be
positioned flat against the Gusset on each side of
the Extension. Tighten the assembly securely.
Step Three
Attach Universal Rack Tray to Extension
Assembly
Turn the Universal Rack Tray upside down
and align the slots in the Gussets with the
threaded inserts that are located on the long
side of the Rack Tray. Attach the bracket
assembly to the Rack Tray with four 1/4" x
1/2" Hex Bolts and 1/4" Lock Washers.
Tighten the fasteners securely. Be careful
not to strip the inserts.
41409/41410 pg 3
Backing
Plate
Backing Plate
5/16 x 3" Hex Bolt
378.30 Lt.
Front Gusset
1/4" x 1/2" Hex Bolt
1/4" Lock Washer
1/4" x 1/2" Hex Bolt
1/4" Lock Washer
Universal Rack Tray
5/16 Hex
5/16 Lock
Nut
Washer
378.31 Rt.
Front Gusset
Extension
Extension
1/4" x 1/2" Hex Bolt
1/4" Lock Washer
1/4" x 1/2" Hex
Bolt
1/4" Lock Washer
0103 Rev. A
Advertisement
