Advertisement
2" Extension (41409 Only),
Qty - 1, Part Number 378.24
Gusset - Rt. Rear/Lt. Front,
Qty - 2, Part Number 378.30
Tools Needed
7/16 Wrench
1/2" Wrench
Adjustable Wrench
Safety Glasses
41409/41410 pg 2
Parts List and Hardware Identification
1.25" Extension (41410 Only),
Qty - 1, Part Number 378.25
Gusset - Lt. Rear/Rt. Front,
Qty - 2, Part Number 378.31
41444 Universal Rack Tray
(Sold Separately), Qty - 1
Step One
Attach Rear Gussets to Extension.
Orient the extension so the sides with holes in them
are vertical. Place a 378.30 and 378.31 Gusset on
each side of the Extension aligned with the 5/16" hole
that is closest to the end. The small flange on the
Gusset near the round hole should lie on top of the
Extension. The flange that runs the length of the
Gusset should point away from the Extension. Attach
both Gussets to the Extension using one 5/16 x 3 Hex
Bolt, Lock Washer, Hex Nut and two Backing Plates.
The Backing Plates should be positioned flat against
the Gusset on each side of the Extension. Tighten the
assembly securely.
Backing Plate, Qty - 4,
Part Number 378.43
7/16 Flat Washer, Qty - 1, Part Number 117.28
Installation
5/16 Hex Nut
5/16 Lock Washer
Backing Plate
378.30 Rt.
Rear Gusset
378.31 Lt.
Rear Gusset
5/16 Hex Nut, Qty - 2,
Part Number 130.02
1/2" x 1" Hex Bolt, Qty - 1, Part Number 378.58
1/4" x 1/2" Hex Bolt, Qty - 4,
Part Number 116.64
5/16 x 3 Hex Bolt, Qty - 2, Part Number 378.60
Extension
Backing Plate
5/16 x 3" Hex Bolt
1/4" Lock Washer, Qty -
4, Part Number 151.80
5/16 Lock Washer, Qty - 2,
Part Number 312.24
0103 Rev. A
Advertisement
