Antenna Connections - Toshiba D-VR4XSU Owner's Manual

Introduction

Antenna connections

If you are using an antenna system, follow these instructions. If you are a Cable TV subscriber, skip ahead
to page 18 for the proper connections.
ANTENNA TO DVD/VCR CONNECTION
The DVD/VCR must be connected between the antenna and the TV. First, disconnect the antenna from the TV and
connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an
antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
Combination UHF/VHF antenna with 75 ohm coaxial cable
1
Combination UHF/VHF antenna with 300 ohm twin lead (flat) wire
2
Separate UHF and VHF antennas
3
VHF
NOTE: If both UHF and VHF antennas have 300 ohm twin lead (flat) wires,
use a combiner having two 300 ohm inputs and one 75 ohm output.
NOTES: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the
antenna to the DVD/VCR properly.
• For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use
of an outdoor type antenna is required.
• If you are not sure about the connection, please refer to qualified service personnel.
16
2H5-01 P12-21
75 ohm coaxial cable
Matching transformer
300 ohm input
75 ohm output
300 ohm twin lead (flat) wire
UHF
300 ohm twin lead (flat) wire
75 ohm coaxial cable
16
DVD/VCR
DVD/VCR
(not supplied)
DVD/VCR
Combiner
75/300 ohm input
75 ohm output
(not supplied)
7/25/05, 23:18
75
75
(su
7
(s