Identification Of Controls; Connections; Remote Control; Antenna Connections - Toshiba SD-V392SU Service Manual

Introduction
Identification of Controls (continued)
The instructions in this manual describe the functions on the remote control. See the page in

Remote control

CALL button 24
DISPLAY button 59
VCR DVD selector button 22
VCR
DVD
Direct channel
selection buttons 28
Number buttons 45
1
INPUT SELECT button 40
4
PROGRESSIVE button 66
TV/VCR button 22
7
COUNTER RESET button 32 INPUT SELECT
PROGRESSIVE
ANGLE button 54
COUNTER RESET
ANGLE
SP/SLP button
34
PLAY MODE button 52
REC/OTR
REC button 34
OTR button 36
TIMER REC button 37
PLAY button 30
REW
REW button 30
SLOW button
31 SLOW
MARKER button
51
ZERO RETURN button
32
ZERO RETURN
JUMP
JUMP button 50
VCR MENU
SETUP
VCR MENU button 23
SETUP button 47
CH –
Direction buttons 45
CANCEL
( / / / )
SET +/- buttons 23
Channel +/– buttons 34
CANCEL button 37
12

Connections

Antenna connections

If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber, skip ahead to page 16
for the proper connections.
Antenna to DVD/VCR connection
The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and
connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna
system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
1 Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
75 ohm Coaxial Cable
2 Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire
Matching Transformer 300 ohm Input 75
300 ohm Twin Lead (Flat) Wire
3
Separate VHF and UHF Antennas
Combiner 75/300 ohm Inputs 75 ohm output
UHF
VHF
300 ohm Twin Lead (Flat) Wire
75 ohm Coaxial Cable
Note: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and
one 75 ohm output.
Notes: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to
the DVD/VCR properly.
• For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type
antenna is required.
• If you are not sure about the connection, please refer to qualified service personnel.
14
for details.
Power ( ) button 22
EJECT button (VCR) 29
CALL
DISPLAY
OPEN/CLOSE button (DVD) 42
EJECT
ATR button 31
2 3
SUBTITLE button 56
OPEN/CLOSE
5 6
AUDIO SELECT button
AUDIO button 55
8 9 0
AUDIO SELECT ATR CLOCK/COUNTER button 33
TV/VCR AUDIO SUBTITLE
INDEX + button 33
SP/SLP
PLAY MODE A-B RPT CLOCK/COUNTER
SKIP button 44
INDEX INDEX
– +
TIMER REC SKIP SKIP
A-B RPT button 52
INDEX – button
33
SKIP button 44
PLAY
FWD button 30
FWD
STOP button 30
PAUSE/STILL
STOP
PAUSE/STILL button 31
TOP MENU button 54
MARKER TOP MENU RETURN
RETURN button 58
CM SKIP
SET + MENU ZOOM
CM SKIP button 31
CH +
ZOOM button
ENTER 50
SET –
*MENU button 54
ENTER button 23
* MENU button
Use the MENU button to display the menu included on
many DVD video discs. To operate a menu, follow the
instructions in "DVD Menu."
54
DVD/VCR
IN
(ANT)
OUT
(TV)
DVD/VCR
IN
(ANT)
ohm output (not supplied)
OUT
(TV)
(not supplied)
DVD/VCR
(not supplied)
IN
(not supplied)
(ANT)
OUT
(TV)
Inserting Batteries
1
Slide the battery compartment
cover in the direction of the
arrow.
39
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER (
• Select your desired operating mode (DVD or VCR) using VCR DVD.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press CH + or CH – to move through the channels one channel at a time.
• The CH +/– ( /
• You can directly access specific channels using Number buttons.
• Each press of VCR DVD on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
DVD/VCR to TV connection
After you have connected the antenna to the DVD/VCR, you must connect the DVD/VCR to the TV.
Below are 3 common methods of connecting your DVD/VCR to a TV. Find the type of TV you are using and follow the
connection diagram.
This DVD/VCR has a single 75 ohm output for connection to a TV. If your TV has separate VHF and UHF antenna
inputs (numbers 2 and 3 below), use a splitter to connect the DVD/VCR to the TV for VHF and UHF reception.
75 ohm Coaxial Cable (supplied)
75 ohm Coaxial Cable
(supplied)
75 ohm Coaxial Cable
(supplied)
2 Install two "AAA" batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
) to turn the DVD VCR on or off.
) and SET +/– ( / ) are also used to navigate on-screen menu system.
TV
Note:
VHF/UHF IN
TV with single 75 ohm VHF/UHF antenna
input
TV
Note:
70.
Splitter 75 ohm Input
75/300 ohm outputs
(not supplied)
80.
TV with 300 ohm UHF and 75 ohm VHF
antenna inputs
TV
Note:
UHF
Splitter 75 ohm Input
300 ohm outputs
(not supplied)
VHF
TV with 300 ohm UHF and 300 ohm VHF
antenna inputs
3 Replace the compartment
cover.
Approx. 7 meters
13
If a VHF or UHF antenna is used,
set the TV/CATV menu option to
the "TV" mode.
If a VHF or UHF antenna is used,
set the TV/CATV menu option to
the "TV" mode.
If a VHF or UHF antenna is used,
set the TV/CATV menu option to
the "TV" mode.
15