EWM T 4.01 Operating Instructions Manual page 58

Functional characteristics
Machine configuration menu
Display
1
for AC welding machines only.
2
For machines with filler wire (AW) only.
3
for components for automated welding (RC) only.
58
Setting/selection
Service menu
Any changes to the service menu should be agreed with the authorised service
personnel.
Reset (to factory setting)
------- Disabled (ex works)
------- Reset the values in the machine configuration menu
------- Complete reset of all values and settings
Resetting is performed when exiting the menu (
Automated/Manual (rC on/off) operating mode
Select machine/function control
------
with external control voltages/signals
------
with machine control
Software version query (example)
07.= ------ system bus ID
03c0= --- version number
System bus ID and version number are separated by a dot.
Cable resistance alignment > see 5.1.12 chapter
Only qualified service personnel may change the parameters!
TIG HF start (soft/hard) switching
------- soft ignition (factory setting).
------- hard ignition.
Ignition pulse limit
Setting 0 ms–15 ms (increments of 1 ms)
PCB state – qualified service personnel only!
).
3
099-00T401-EW501
21.06.2018