Functional Description - Makita BTW072 Instruction Manual

FUNCTIONAL
DESCRIPTION
2
1. Battery cartridge
2. Button
1
2
1. Battery cartridge
2. Terminal cover
3. Charging lights
4. Battery charger
8
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
001251
• To remove the battery cartridge, withdraw it from the tool
while pressing the buttons on both sides of the cartridge.
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
1
it into place. Always insert it all the way until it locks in
place with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone around you.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Charging
001253
1. Plug the battery charger into the proper AC voltage
source. Two charging lights will flash in green color
repeatedly.
3
2. Insert the battery cartridge into charger until it stops
adjusting to the guide of charger. Terminal cover of
4
charger can be opened with inserting and closed with
pulling out the battery cartridge.
3. When the battery cartridge is inserted, the charging light
color will change from green to red and charging will
begin. The charging light will keep lighting up lit steadily
during charging. One red charging light indicates
charged condition in 0 - 80% and two red ones indicates
80 - 100%.
4. With finish of charge, the charging lights will change
from two red ones to two green ones.
5. If you leave the battery cartridge in the charger after the
charging cycle is complete, the charger will switch into
its "trickle charge (maintenance charge)" mode which
will last approximately 24 hours.
6. After charging, unplug the charger from the power
source.