Table of Contents
Advertisement
(7) WHITE BAL (WHITE BALANCE)
Move the cursor to the position shown in fig.
Use the
SELECT switches to select
AUTO, MANUAL in the WHITE BAL settings.
AUTO : The white balance is automatically
adjusted corresponding to the color
temperature variations on the ob-
ject. The camera is applicable to a
color temperature range of 2500-
10K. Press the SELECT switch to
enter AUTO set mode. Use the
SELECT switches to adjust the shift
value of the convergence point.
When data becomes big in the positive side, a convergence point is altered in
the red side. When data becomes big in the negative side, a convergence point is
altered in the blue side.
MANUAL : Press the SELECT switch to enter the MANUAL SETTINGS. Use the
SELECT switches to adjust R Gain (Red) and B Gain (Blue) until the desired
white balance is reached. Press SELECT to exit the manual settings.
INDOOR1 : Optimum setting for the white balance when the color temperature is 3000K
indoors with an incandescent lamp.
INDOOR2 : Optimum setting for the white balance when the color temperature is 4000K
indoors with a fluorescent lamp.
OUTDOOR : Optimum setting for the white balance when the color temperature is 5200K
in an outside environment.
NOTES
• If the optimum white balance cannot be obtained, then try to set AWB-RNG
to WIDE. (Refer to 8.3 (11).)
(8) ID. = Camera ID.
Refer to 8.2 (6).
(9) ID. POS = Camera ID. Position
Refer to 8.2 (7).
S H U T T E R
D / N : M I D
WD R
O N
A L C
L E V :
B L C
A U T O
G A I N
S T D
S H A R P N E S S M I D
WH I T E - B A L A U T O :
N E X T
E X I T C A N C E L D E F A U L T
0 0
0 0
19
Advertisement
Table of Contents
