4. CONNECTION
Lens
Camera body
Cautions
• When installing the camera, unplug the power source of the camera and all connected
equipment.
• Please use a monitor which has BNC or S-Video input.
• A coaxial cable of 75Ω or S-Video cable is needed to connect a video monitor etc.
• For DC power supply connecting to DC 12 V terminal, use a power supply with the
specifications described below.
Power supply voltage: DC12V ±10%
Current rating:
Ripple voltage:
Connector:
(1) Install the lens to the camera body. For available lenses, refer to the item "5 LENS
ADJUSTMENT."
(2) Connect a coaxial cable from the VIDEO terminal to the video input terminal of the
video monitor etc.
(3) Connect equipment, turn on the power supply to the camera, and then turn on the
power to the equipment.
(4) Adjust the lens by referring to item 5, obtain the best camera performance.
VIDEO terminal
Coaxial cable of 75Ω
DC IN 12V terminal
DC 12 V power supply
2.0 A or more
50 mV (p-p) or less
HR10A—7P—4S by HIROSE Electronics Co., Ltd.
Pins 1, 2: +12V
Pins 3, 4: GND
- 10 -
Monitor