Selecting the signal source
To select the signal source to view:
1. Press TV/VIDEO on the remote control or the TV.
2. Use the CHANNEL NUMBERS on the remote control to select
the number (0–5) that corresponds with the desired source.
(You can also repeatedly press the TV/VIDEO button on either the
remote control or the TV to cycle through the sources.)
SOURCE SELECTION
0: ANT 1
1: VIDEO 1
2: VIDEO 2
3: VIDEO 3
4: ColorStream
5: ANT 2
0–5: TO SELECT
To display the current signal source:
Press TV/VIDEO or RECALL. The current source displays in
purple.
Programming channels into the TV's memory
When you press CHANNEL
the TV stops only on the channels stored in the TV's memory.
Note: To tune the TV to a channel not programmed into the memory,
use the CHANNEL NUMBERS on the remote control.
Follow the steps below and on the next page to program channels into
the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the TV's memory. After the channels are stored auto-
matically, you can manually add or erase individual channels (see
page 18).
If you use both ANT-1 and ANT-2 terminals, you will need to
program channels for each signal source.
To program channels automatically:
1. Press MENU.
2. Press
or
to highlight the SET UP menu.
x
•
3. Press
or
to highlight TV/CABLE.
y
z
4. Press
or
to highlight TV (if you use an antenna) or CABLE (if
x
•
you use cable).
5. Press
to highlight CH PROGRAM.
z
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
ANT1/2:
[ANT1] ANT2
TV/CABLE:
[TV]
CABLE
CH PROGRAM
ADD/ERASE:
[ADD] ERASE
MORE
[
]
SELECT [
]
MOVE
6. Press
or
to start automatic channel programming ("CH
x
•
PROGRAM" displays on-screen). The TV automatically cycles
through every TV or cable channel (depending on which you
selected), and stores all active channels in the TV's memory.
7. When automatic channel programming is complete, the message
"CH Programming Completed" appears.
8. Press CHANNEL
▲▼
to view the programmed channels.
▲▼
on the TV or remote control,
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
ANT1/2:
[ANT1] ANT2
TV/CABLE:
[TV] CABLE
CH PROGRAM
ADD/ERASE:
[ADD] ERASE
MORE
MOVE
[
]
SELECT [
]
TV Front Panel
DEMO
MENU TV/VIDEO
VOLUME
TV/VIDEO
RECALL
RECALL POWER
LIGHT
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
TV/VIDEO
2
1
3
CH (Channel)
CH
4
5
6
Channel
Numbers
8
9
7
VOL
CH RTN
100
0
ENT
ADV/
PIP CH
MENU
FAV
ENTER
FAV
ADV/
PIP CH
STOP SOURCE
PLAY PIP
REC
TV/VCR REW
FF
STILL LOCATE SWAP
CT-9946
CHANNEL
17