Selecting The Signal Source; Programming Channels Into The Tv's Memory; Programming Channels Automatically - Toshiba 32A62 Owner's Manual

Selecting the signal source

Use the TV/VIDEO button on the remote control or TV to select the
signal source connected to your TV.
• Pressing TV/VIDEO on the remote control displays the current
signal source in purple. Press 0–4 to select the source.
0: TV
1: VIDEO 1
2: VIDEO 2
3: VIDEO 3
4: ColorStream
0–4: TO SELECT
• Pressing TV/VIDEO on the TV changes the current signal source.
Repeatedly press the button to select the source.
To verify the signal source:
Press the TV/VIDEO button on the remote control once. The
current signal source displays in purple.

Programming channels into the TV's memory

When you press CHANNEL
the TV stops only on the channels stored in the TV's memory.
Note: To tune the TV to a channel not programmed into the memory,
use the CHANNEL NUMBERS on the remote control.
Follow the steps below and on the next page to program channels into
the TV's memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area
and store them in the TV's memory. After the channels are stored
automatically, you can manually add or erase individual channels
(see page 18).
To program channels automatically:
1. Press MENU.
2. Press or to highlight the SET UP menu.
x •
3. Press or to highlight TV/CABLE.
y z
4. Press or to highlight TV (if you use an antenna) or CABLE (if
x •
you use cable).
5. Press to highlight CH PROGRAM.
z
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
TV/CABLE: [TV] CABLE
CH PROGRAM
ADD/ERASE: [ADD] ERASE
MORE
SELECT [ ]
MOVE [ ]
6. Press or to start automatic channel programming ("CH
x •
PROGRAM" displays on-screen). The TV automatically cycles
through every TV or cable channel (depending on which you
selected), and stores all active channels in the TV's memory.
7. When automatic channel programming is complete, the message
"CH Programming Completed" appears.
8. Press CHANNEL ▲▼ to view the programmed channels.
(Continued on next page)
▲▼ on the TV or remote control,
SET UP
LANGUAGE:
[ENGLISH] FRANCAIS ESPANOL
TV/CABLE: [TV] CABLE
CH PROGRAM
ADD/ERASE: [ADD] ERASE
MORE
[ ] SELECT [ ]
MOVE
17
TV/VIDEO
CHANNEL y z
MENU TV / VIDEO VOLUME CHANNEL
y z x •
MENU
RECALL POWER
LIGHT
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
TV/VIDEO
2 3
1
CH CH (Channel)
4 5 6
Channel
Numbers
9
7 8
VOL
CH RTN
100 0 ENT
ADV/
PIP CH MENU
FAV
ENTER FAV
ADV/
PIP CH
POWER