Table of Contents
Advertisement
WIRING WITH THE RGX COMMUNICATIONS CARD
The depiction below shows the connections that need to be made to allow communication between the RGX and
TS110 display. If you have a RGX card use the following wiring scheme.
Figure 3-1 COM3 Pin Configuration
COM3: Using a 2 conductor cable with shield
connect a 9-PIN connector to one end. Con-
nect wires to the pins as show in Figure 3-1.
Connect the other end to the RGX commu-
nications Card. Connect the red (+) , black
(-) and shield (G) wires to J7 (MAIN) on
the RGX card. Using the RGX web-interface
change the J7 port settings to the following:
Function: BCS SERVER
Buad Rate: 9600
Installation |
24V Power Terminal: This terminal
should be connected to a 24V AC
or DC power source.
Advertisement
Table of Contents
