Applications; Battery Removal/Installation; Charging - Hitachi WH 14DSDL Handling Instructions Manual

APPLICATIONS

<WH14DSDL / WH18DSDL>
Driving and removing of small screws, small bolts, etc.
<WR14DSDL / WR18DSDL>
Tightening and loosening of all types of bolts and nuts, used for securing structural items.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).

CHARGING

Before using the power tool, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger, as shown
in Fig. 3, 4.
3. Charging.
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1 on
page 34)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in Table 1
on page 34, according to the condition of the charger or the
battery.
Pilot lamp
33
English
Handle
Pull out
Latch
Push
Battery
Fig. 2
Battery
Charger
<UC18YRSL>
Fig. 3
Pilot lamp
Charger
<UC18YFSL>
Fig. 4
Battery