Thing To Watch For - Pelgrim TBF 9050 Manual

Things to watch for
The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
The furniture that is in contact with the
appliance must be heat resistant (T 90 °C).
During repair and cleaning the appliance
needs to be disconnected from the power
supply (electricity and gas). Remove the
plug from the wall socket or turn the switch
in the metre cupboard to zero. Turn off the
gas tap in the feeder pipe.
This appliance must only be used for the
purpose for which it is designed, i.e. the
preparation of food. Use for any other
purpose should be considered to be
improper and dangerous. We accept no
responsibility whatsoever for damage
caused by incorrect, improper or irrational
use of the appliance.
When boiling and frying the hob gets hot.
Please pay close attention to small
children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the
kitchen. This will produce a damp
atmosphere.
When a gas cooking appliance is being
used heat and moisture is produced in the
area where the appliance is situated. Make
sure that the area is sufficiently ventilated;
open natural ventilation openings or fit a
mechanical ventilator (extractor). When the
hob is used for longer periods extra
ventilation may be needed, such as an open
window or a higher setting on the ventilator
(extractor).
The glass oven door can heat up when using
the oven at maximum temperature for a long
time (e.g. during grilling). Act with care if
children are nearby.
Cords to electrical appliances - e.g.
a mixer - can get caught between the door of
the convector oven or may accidentally touch
the cooking zones.
Do not use the storage drawer for
inflammable or slightly ductile materials.
Affix the switch protection plate before
using the grill. In this way you will prevent
the control switches from overheating.
Always cool the oven with a closed oven
door.