Troubleshooting - BainUltra GEYSAIR Addendum To The Owner's Manual

T R O U B L E S H O O T IN G | gey sa ir
situation
air jets seem cool.
Jets are too hot
leD does not work.
www.bainultra.com
Printed in Canada. Copyright © september 2012 Bainultra inc. all rights reserved. 45100169
some products, specifications, and services mentioned in this manual are described
in pending patent applications or are protected by patents.
a ddendum to the owner' s manual
t m
solutions
temperature of air injected into bath is directly proportional to the
speed of the turbine. the higher the speed, the warmer the air is. a
simple way to check if your air-heater or heaters are working properly
is to turn on the system at the highest speed (if your control offers a
range of intensities) with no water in the bath (there is absolutely no
risk to the system). after 3 to 5 minutes, the heated backrest or back-
rests should be warm to the touch and jets should also seem warm
when you bring your hands close to them.
• Check the turbine air intake. it should not be too cold nor too warm.
ideally, the temperature should be between 72°f (20°C) and 86°f
(30°C).
• Check that distance between turbine and bath is not too great.
if possible, insulate air line along its entire length. see turBine
installation section of this manual.
BatH witH geysair
• the geysair option is not activated on the control panel.
• the geysair hot water supply hose is not connected.
• the geysair hot water supply hose is connected to a cold water supply.
• the hot water hose is too long or not properly insulated.
• the geysair intensity regulator is obstructed.
• for any remote installation, the turbine and the geysair are not
properly connected.
• deactivate the geysair option, if applicable.
• if the geysair option is installed on the bath, lower the temperature
of the water heater.
a led has a 100 000-hour lifecycle.
• verify wiring and connections.
• unplug and plug again led module power supply. you should see a
light flash in every led. if not, check your power source. if led flash
but still don't work, please call Bainultra.
supersedes page 70 of owner' s Manual
23