Chapter 5: Cooling Module Installation And Removal; Installing The I/O Cooling Module - Avaya Virtual Services Platform 9000 Installation Manual

Chapter 5: Cooling module installation and
This section describes how to install the cooling modules in the Avaya Virtual Services Platform 9000.
Install a cooling module to provide cooling to the interface, Switch Fabric (SF), and Central Processor
(CP) modules. Installation takes 2 to 5 minutes.

Installing the I/O cooling module

Install the I/O cooling module in the front of the chassis to provide cooling to the interface and
CP modules. You must install two I/O cooling modules in the chassis. You can hot swap the
cooling modules.
Warning:
Risk of personal injury
Remove the cooling modules using the provided handles. Be careful to keep your fingers
out of the fan blades. When you remove a cooling module, allow time for the fans to spin
down before you fully withdraw the cooling module.
Procedure
1. Locate the bay where you want to install the cooling module.
2. Slide the cooling module into the chassis.
Installation — Cooling Modules
removal
June 2013 37