Setup - Toshiba XM-6802B User Manual

SETUP – XM-6802B CD-ROM
The following steps must be performed to properly install your drive:
•
Set CD-ROM Drive Jumper Settings
•
Connect Audio Cable (optional)
•
Attach IDE BUS Cable
•
Attach Power Cable
•
Mount Drive
Jumper Settings
The mode select jumpers are 6 straight angle pins located on the rear of the CD-ROM drive.
By placing a jumper on the pins, you can select the following functions:
CS
SL
MA
In most installations, jumper should remain in the MA position (factory default). It is recommended that
you install your CD-ROM drive only on the secondary IDE BUS. If you are installing on primary IDE BUS,
your hard drive would then be the Master, and you should set your CD-ROM drive to the Slave position
(SL)
3
Drive is configured using host interface signal CSEL
Configures drive as Slave
Configures drive as Master (default mode)
Figure 1.Mode Select Jumper
Figure 2.Jumper Locations