Table of Contents
Advertisement
o Try to change the baud rate and channels on both sides (refer to Configuring the
channel settings, page 34).
NOTE:
In this situation, lower the baud rate.
o Improve the antenna's location.
o Replace P-COMM-RF10-9-S COMMUNICATOR RF (Refer to Replacing the RF-card,
page 55).
12.5 Voice card
Voice does not function
Figure 13: Voice Card Location
1. Refer to Testing voice, page 25 and perform voice test.
2. Change the parameters as required (refer to Setting the voice , page 24).
NOTE:
Do not forget to confirm by moving the cursor to the '
3. Verify speaker cable is connected.
4. Turn volume trimmer on voice card until required volume is reached (Figure 14) (Refer to
Figure 1, page 11 to see the voice card location).
5. If none of the above helps, contact your dealer.
TEST'
© Munters AB, 2018
parameter and pressing
'ENTER
'.
51
Advertisement
Table of Contents
