Prune Stations; Operating Your Radio - Fm - PERFECTPRO DAB+MATE Operating Instruction

Prune stations

If you move to a different part of the country, some of the stations which were listed may no longer
be available. Also from time to time, some DAB services may stop broadcasting, or may change
location or frequency. Stations which cannot be found, or which have not been received for a very
long time are shown in the station list with a question mark. The prune stations function will delete
the marked DAB stations from your station list.
1. Press and hold the Info/Menu button and the display will show "Full scan".
2. Rotate the Tuning control knob to find "Prune". Press and release the Tuning control knob to enter
adjustment mode. Then rotate the Tuning control knob to select "Yes" or "No". To activate the Prune
function select "Yes", and press and release the Tuning control knob to confirm the setting.
3. If you do not wish to prune stations, select "No" and then press and release the Tuning control
knob to confirm the setting.
Note:
If you have moved your radio to a different part of the country you should also carry out a search for
new stations (please see the section 'Finding new stations').
Operating your radio – FM
1. Straighten the antenna properly above the radio. Press the Power On/Off button to switch on your
radio.
2. Press the Source button to select FM waveband.
3. To scan up in frequency, first rotate the Tuning control knob in a clockwise direction and then press
the Tuning control knob. Your radio will scan in an upwards direction (low frequency to high frequency)
and stop automatically when it finds a station of sufficient strength. To scan down in frequency,
first rotate the Tuning control knob in a anti-clockwise direction and then press the Tuning control
knob within 10 seconds. Your radio will scan in a downwards direction and stop automatically when
it finds a station of sufficient strength. After a few seconds the display will update. The display will
show the frequency of the signal found. If the signal is strong enough and there is RDS data present
then the radio will display the station name.
4. When the waveband end is reached, your radio will recommence tuning from the opposite waveband
end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
GB
13