Table of Contents
Advertisement
9:1 Lockable legrests
Transit is supplied with lockable
legrests as standard. They are remov-
able and can be swung to the side or
under the seat. To remove the legrests
press down on the red button (A) and
lift. To fasten the legrests press down
on the red button (B) as shown in the
illustration, put the legrest into place
and release the button. The legrest is
now locked, see picture (A).
9:2 Height of the footrests
Transit is supplied with divided,
flip-up footrests that are adjustable in
height, angle and depth.
Height Loosen the locking handle (A)
on the legrest fully. Set the height.
Replace the screw and handle. Tighten
securely. Max. length: 51 cm. Min.
length: 33 cm.
9:3 Angle and depth of the footrests
The footrests can also be adjusted in
angle and depth.
Angle Loosen the screws (A) slightly.
Adjust to the required position and
tighten again.
Tools: 5 mm Allen key.
9 Settings footrests
Never stand on the footrests
as the chair may tip!
(!) -To make the footrests
higher than standard there
are also short/narrow legrests
with footrests with 8 cm
shorter attachment tubes.
- To make the footrests lower
than standard there are
footrests with 10 cm longer
attachment tubes.
For outdoor use the footrests
should be 4-5 cm above
ground level. Never stand on
the footrests as the chair may
tip!
Depth
The sides of the footrests
have different lengths. By changing
the left side for the right they will
extend further forwards.
(!) If the depth is altered,
the angle must also be adjusted.
14
B
A
A
A
Advertisement
Table of Contents
