Page 1
Shower Panels Important! This manual is the property of the customer and must be retained with the product for maintenance and operational purposes. Product Manual...
Page 2
A range of shower panels designed to deliver water consistently at a desired temperature. All Rada Shower Panels in the range are available in a Stainless Steel or White finish. Product Ranges (covered by this guide): Rada PA-TF (stainless) Rada PA-215TF (stainless) Rada PA-TFW (white)
INSTALLATION General Installation must be carried out in accordance with these instructions, and must be conducted by designated, qualified and competent personnel. The installation must comply with the “Water Supply Regulations 1999 (Water Fittings)” or any particular regulations and practices, specified by the local water company or water undertakers.
Page 5
Run the supply pipe(s) through the Mounting Bracket. Note! Make sure that the supply pipe(s) are securely fixed to prevent movement when connected to the Flexible Hoses inside the Panel. Fit the Isolating Valve(s) to the pipework. Turn on the water supply and open the Isolating Valve(s) to flush through the supply pipe(s).
Page 6
Rada PA ETF / PA ETFW Panels Only Plastic Conduit (not supplied) Supply Pipe Earth Terminal Run the supply cable through the Mounting Bracket. Note! The cable through the Mounting Bracket must be routed through Plastic Conduit of suitable diameter (not supplied). The Plastic Conduit must be securely fixed.
Page 7
Rada PA-V8F / PA-V8FW-LL and LR Panels Only The outlet elbow can be moved from the right hand side (RH) to the left hand side (LH) to suit the installation of the shower fittings. Blanking Plug Elbow Washer Outlet Hose Disconnect the outlet hose from the elbow.
Finish the Installation Remove the Shower Panel and the Hook and locate the Shower Panel onto the Mounting Bracket. Note! Retain the Hook inside the Shower Panel for servicing purposes. Fix the bottom of the Shower Panel to the wall using the Securing Screws (supplied).
Page 9
Caution! Make sure that you avoid buried pipes and cables when you drill the wall. Drill the six fixing holes. Note! The installer should use an appropriate wall fixing arrangement to suit the wall type or surface (wall fixings not supplied).
MAINTENANCE General Rada products are precision-engineered and should give continued superior and safe performance, provided: They are installed, commissioned, operated and maintained in accordance with these recommendations. Periodic attention is given as necessary to maintain the product in good functional order. Cleaning Many household cleaners contain abrasive and chemical substances, and should not be used for cleaning plated or plastic fittings.