Product-Dependent Symbols; Product Information; Basic Information On Safety; Symbols On The Product - Hilti PD-S Manual

1.3

Product-dependent symbols

1.3.1

Symbols on the product

The following symbols are used on the product:
Measure / Continuous measurement
Area measurement / Units
ON / Delete / OFF
1.4

Product information

products are designed for professional users and only trained, authorized personnel are permitted
to operate, service and maintain the products. This personnel must be specifically informed about the
possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Laser range meter
Generation
Serial no.
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration issued by the certification department can be found at the end of
this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2 Safety
2.1

Basic information on safety

In addition to the information relevant to safety given in each of the sections of these operating
instructions, the following points must be strictly observed at all times. The product and its ancillary
equipment can present hazards if used incorrectly by untrained personnel or if used not in accordance with
the intended use.
▶ Keep all safety instructions and other instructions for future reference.
▶ Stay alert, watch what you are doing and use common sense when operating the product. Do not use
the product while you are tired or under the influence of drugs, alcohol or medication. A moment of
inattention while operating the product can result in serious personal injury.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Laser radiation in excess of Class 2 can be emitted if the product is opened without correct procedure
being followed. Have the product repaired by Hilti Service only.
▶ Do not tamper with or attempt to make alterations to the product.
▶ Before starting to use the product, always make sure that it is full working order.
▶ Readings taken through panes of glass or similar materials can falsify the result of measurement.
▶ People passing through the laser beam or other quick changes in measuring conditions can falsify the
result of measurement.
▶ Never aim the product against the sun or other powerful light sources.
▶ Take the influences of the surrounding area into account. Do not use the device where there is a risk of
fire or explosion.
▶ Follow the directions for operation, care and maintenance in the operating instructions.
2 English
Printed: 29.03.2018 | Doc-Nr: PUB / 5410155 / 000 / 00
PD-S
01