Installation Of The Housing; Removing The Housing - WATERKOTTE EcoTouch DS 5050T Planning And Installation

Installation

6.3 Installation of the housing

6.3.1

Removing the housing

04.12.2015
To avoid damage, the delivered housing parts are not installed.
After preparation of all connections, mount the housing parts to the intend-
ed positions (insert and press).
A disassembly tool is delivered with the heat pump. Use this tool to avoid
damage while you are removing the housing parts.
Procedure:
 Keep enough clearance with the tool to the upper and lower metal edge.
So you can't damage the retaining bolts (see Figure).
 The removal tool is driven with moderate force, by hand, into the gap
between the front and side panel.
18 / 48
Copyright  2014 by: WATERKOTTE GmbH. Subject to changes.