ADT Safewatch Pro 3000 Programming Manual page 16
Hide thumbs
Also See for Safewatch Pro 3000:
- User manual (57 pages) ,
- Installaton manual (88 pages) ,
- System manual (14 pages)
Need help?
Do you have a question about the Safewatch Pro 3000 and is the answer not in the manual?
Questions and answers
What is a check 90 trouble signal
A CHECK 90 trouble signal on the ADT Safewatch Pro 3000 indicates that RF (radio frequency) interference may be impeding the operation of wireless sensors in the system. This may be caused by changes in the wireless environment that prevent the receiver from hearing a particular sensor. CALL FOR SERVICE if this occurs.
This answer is automatically generated
How to remove 103 lngrng error code permanently from the key I no longer have adt monitoring service
To permanently remove the 103 LngRng Radio error code from an ADT Safewatch Pro 3000 without a monitoring service, you need to disable the cellular radio in system programming. Follow these steps:
1. Enter programming mode:
- Power down the system.
- Power it back up.
- Within 50 seconds, press [*] and [#] at the same time.
2. Once in programming mode, disable the radio module:
- Enter *29.
- When asked to enable the Long Range Radio, press 0 (to disable).
- Press * to save.
3. Exit programming mode:
- Press *99 to exit and allow future re-entry.
This will disable the radio and stop the 103 error code from appearing.
This answer is automatically generated