Polycom EagleEye Director Quick Integration Manual page 2

EagleEye Director needs the mix of all the remote audio so that the EagleEye Director can properly discern between
audio played into the room from the remote sites (i.e., remote talkers) and the local talker audio in the local room when
determining camera positioning.
Integrating the SoundStructure with the HDX codec and EagleEye Director
The HDX codec / EagleEye Director solution can be upgraded with one or more SoundStructure devices by replacing the
analog outputs 1L and 1R from the HDX codec with two analog outputs (outputs 1 and 2) to the Amplifier and two more
outputs (outputs 3 and 4) to the EagleEye Director as shown in Figure 2.
Figure 2 - Integrating SoundStructure with an EagleEye Director uses four balanced audio cables and one conference link interface to
the HDX codec.
The four balanced audio cables used are connected straight‐through with pin 1 connected to pin 1, pin 2 connected to
pin 2, and pin 3 connected to pin 3 as shown in Figure 3.
Figure 3 - A standard balanced audio cable with 3.5mm terminal block connectors.
Before connecting the SoundStructure system to the HDX codec, it is recommended that you enable LiveMusic mode in
the HDX codec. To do this navigate the HDX UI from Admin Settings > Audio Settings and select LiveMusic mode. This
2