Wahl Blitz Instructions Manual page 14

Blitz Trimmer
water. Simply let them air dry.
After cleaning, replace the cutter bars by pressing down gently. Carefully
replace the foil head, snapping it into place.
From time to time, depending on the density of your beard, you will need to
replace the cutters and foils. If you notice that it is taking you longer to shave,
or if your face starts to feel some irritation, or if the foil seems to become
warm to the touch, it is probably time to replace the cutters and foils. Replace
the cutters and foils only with WAHL parts (92025).
BLADE CARE
Trimmer blades have precision-hardened and ground cutting teeth. Blades
should be handled carefully and never bumped or used to cut dirty or
abrasive material. Clean with the included brush.
Heads should be removed from the trimmer prior to rinsing in water. After
rinsing, allow the heads to air dry completely before reattaching to the
trimmer body. The trimmer body should always be kept away from water to
maximize the life of the motor, battery, and control components.
OILING BLADES
For best results, put one or two drops of Wahl Clipper Oil on
the blades only when necessary, or approximately once a month. Motor
bearings are permanently lubricated, do not attempt to oil.
When oiling your trimmer, turn the trimmer "ON," hold the unit with the blades
facing DOWN and squeeze one or two drops of oil onto the blades. Wipe off
excess oil with soft cloth.
NOTICE—DO NOT OVER OIL!
Excessive oiling or application of liquids will cause damage if allowed to seep
back into motor.
BLADE CLEANING/STORAGE
Before storing your trimmer, use the cleaning brush to whisk any loose hairs
from the unit and the blades. Store unit in such a manner so that blades are
protected from damage.
This appliance should be stored in a manner where it is not subjected to
Crushing, Heating above 100°C (212°F), or Incineration.
14