Temperature Adjustment /4; Appliance Description /4; Replacing The Interior Lamp /4; Repositioning The Door /4 - Beko WSA 29000 Instructions Of Use

EN
Temperature adjustment
The internal temperature could be adjusted by
means of the button from the thermostat.
The temperatures obtained inside the
appliance could oscillate depending on the
usage conditions: location, environmental
temperature, doors opening frequency, foods
quantity. Position of thermostat button will
change depending on these conditions.
Generally, for an environmental temperature
0
of 30 C, thermostat button will be settled on a
medium position. This position can be
adjusted subsequently towards plus or minus
according to the user's wish
The thermostat (placed in the rear side of the
appliance, in the ventilation grill) also assures
the automatic defrost of the refrigerator.
During the defrost period the temperature
inside the refrigerator could reach up to
0
+12 C, but it decreases up to 2-3
Avoid some positions of thermostat button
that could involve a continuously running of
the appliance.
Appliance description
(Item 1)
1 - Lamp switch
2 - Lamp box - inside lighting
3 - Fan
4 - Grids
5 - Water collector
6 - Door support roller
7 - Adjustable foot
Replacing the interior lamp
To change the Bulb/LED used for illumination
of your refrigerator, call your Authorised
Service.
The lamp(s) used in this appliance is not
suitable for household room illumination. The
intended purpose of this lamp is to assist the
user to place foodstuffs in the
refrigerator/freezer in a safe and comfortable
way.
The lamps used in this appliance have to
withstand extreme physical conditions such as
temperatures below -20°C.
0
C.
4
Instruction for use
Repositioning the door
The door of your „Heavy-duty chilled vertical
cabinet" is designed to operate towards both
sides at your convenience. If you want the
door to open towards the other side, please
call the nearest authorized maintenance
service for assistance.
Proceed in numerical order (Item 7).
The appliance defrosting
The defrosting is fully automatic and takes
place at pre-set periods. It is not necessary
any intervention from you.
The resulted water is collected in a drip pan
located on the compressor. The water
evaporates there because of the heat issued
during its working (Item 5).
Important !
Keep clean the collector and draining hose for
the water flow resulted after defrosting. To do
so, use the supplied trench part. Check the
hose to be permanently with the end inside
the drip tray on the compressor in order to
prevent the water flow above the electric
wiring or on the floor (Item 6).
Cleaning and care
1. We recommend that you switch off the
appliance at the socket outlet and pull out the
mains plug before cleaning.
2. Never use any sharp instruments or
abrasive substances, soap, househould
cleaner, detergent or wax polish for cleaning.
3. Use luke warm water to clean the cabinet
of the appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution
of one teaspoon of bicarbonate of soda to one
pint of water to clean the intreior and wipe it
dry.
5. Make sure that no water enters the
temperature control box and lamp box.
6. We recommend that you polish the metal
parts of the product (i.e. door exterior, cabinet
slides) with a silicone wax (car polish) to
protect the high quality paint finish.
7. Check door seals regularly to ensure they
are clean and free from food particles.