Safran Sagem Communication myC2-3 Site Technical Documentation page 77

myC2-3
7RROV
-Tweezers
- Iron has to weld
3UpOLPLQDLUH RSHUDWLRQ
1. Remove the battery (Proc sheet 0 01).
2. Remove the lower housing of mobile (Proc sheet 1 01).
3. Remove the keyboard (Proc sheet 1 04))
4. Remove MMI board (Proc sheet 1 07).
5. Remove the flap (Proc sheet 1 09).
6. Remove housing Flap (Proc sheet 1 10).
5HPRYDO SURFHGXUH
1. Unsolder the 2 threads of the
2. Unsolder the 2 threads of the vibreur (2), then extract the vibrator (4).
3. Disassemble ciu/lcd of upper housing flap.
4. Unsolder the FPC, Disconnect of connect BTB.(5), To extract the FPC.
3ODFHPHQW SURFHGXUH
1. Position the FPC. Solder Mass plan (6).
2. Position the vibrator. Solder the 2 threads (red and black) (7).
3. Position the HP. Solder the 2 threads (white and black) (7).
)XUWKHU RSHUDWLRQV
1. Place the flap (Proc sheet 1 09)
2. Place the keyboard ( Proc sheet 1 04).
3. Place the board MMI (Proc sheet 1 07).
4. Place the lower housing of mobile (Proc sheet 1 01).
5. Place of the battery (Proc sheet 0 01)

Contents
5HPRYH DQG SODFH KSYLEUDWRU
)3& /&' IODS
Risk of the procedure :
Damage LCD, FPC, Hp, vibreur
HP ( 1 ), then extract the


REF MTB DTS 8- Indice B - February 21 2006
Proc sheet 2 02
1/1
HP ( 3 ).
 

Procedure
Proc 0 01
Proc 1 01
Proc 1 02
Proc 1 03
Proc 1 04
Proc 1 05
Proc 1 06
Proc 1 07
Proc 1 08
Proc 1 09
Proc 1 10
Proc 1 11
Proc 1 12
Proc 2 02
Proc 3 01
Proc 3 02
Proc 4 01
Symptom
Symp 01
Symp 02
Symp 03
Symp 04
Symp 05
Symp 06
Symp 07
Symp 08
Symp 10
Test
Test 01
Test 02
Test 03
Test 04
Test 05
Test 06

Thread white Hp
Thread black Hp
Thread black vibreur
Thread red vibreur
Page 5-21