Table of Contents
Advertisement
3. Charging
3.1
IMPORTANT: READ THE CHARGER HANDBOOK BEFORE ATTEMPTING TO
CHARGE THE BATTERY.
3.2
NOTE: The PAG MPL50G Battery is put into 'ship mode' prior to
transit, to reduce its rate of self-discharge. The battery can be
activated by connecting it to a charger that is powered-up, or by
linking it to a battery that is already active.
3.3
PAG MPL50G batteries can be charged individually or linked, regardless
of their capacity or state of charge. MPL50G batteries can also be
charged when linked to PAGlink Gold Mount batteries Models PL94
(9306) and PL150 (9313).
3.4
The least-charged batteries are given priority until all the batteries are
in a similar state-of-charge. They will then be fully-charged simulta-
neously. Up to 8 batteries can be linked for charging on each
position. The following PAGlink chargers can be used:
9707A PAGlink PL16 Charger
9711A PAGlink PL16+ Charger
9713
PAGlink Micro Charger
Some Anton Bauer Gold Mount Li-Ion chargers may also be suitable.
The number of linked batteries that can be charged on each position
is dependent on the charger model and firmware version.
8
2-positions, 8 batteries on each
4-positions, 4 batteries on each
1-position, 8 batteries in total
3.5
Charge Times: From fully-discharged to fully-charged:
50Wh Batteries
PL16 Times
1
2
4
6
8
16
3.6
MPL50G batteries display their individual status during charging
on their built-in display.
3.7
The batteries incorporate a temperature sensor which will
inhibit charging if their temperature is below 0°C. See
Specification for the charging temperature range.
Micro Charger Times
01:15
02:00
01:30
04:00
03:00
08:00
04:45
12:00
06:00
16:00
12:00
-
Advertisement
Table of Contents
