Table of Contents
Advertisement
All manuals and user guides at all-guides.com
T H E B A T T E R Y A N D S I M C A R D
If your Vertu phone was purchased at a Vertu store, the
battery and SIM card should have been installed already.
Otherwise, follow the procedure below to install your
SIM card and battery.
The SIM card and its contacts are easily damaged. Be
careful when handling, inserting or removing the card.
Caution. Keep SIM cards and the back cover release key
out of the reach of small children.
Always switch the phone off and disconnect the charger
before removing the battery.
Do not remove the release tab or the protective plastic film
from the battery as this will damage the battery.
With the back of your Vertu phone facing you, position
>
the back cover release key (01) very carefully into the
slot of the locking screw. Ensure the key does not slip
out of the slot.
Turn the locking screw (02) a quarter of a turn
>
anti-clockwise, and gently lift off the back cover as
shown. If you accidentally remove the back cover while
the phone is switched on, the phone will automatically
switch off.
Attach the back cover release key to your keyring for
convenience.
0 3
Remove the plastic placeholder (03) from your Vertu
>
phone before inserting the battery.
Retain the plastic placeholder for future use. If you
need to remove the battery, insert the plastic
placeholder before replacing the back cover to make
it easier to remove the back cover.
0 1
Slide the retaining bar (04) towards the top of your
>
Vertu phone and then pivot upwards.
0 2
Insert the SIM card, ensuring that the bevelled corner
>
(05) is located top right and the gold contact area is
facing downwards.
Return the retaining bar to its original position and
>
slide it towards the bottom of the phone. The retaining
bar should firmly lock into place.
For availability and information on using SIM card
services, contact your SIM card vendor. This may be
the service provider, network operator, or other
vendor.
07
Insert the battery (06) bottom end first with the release
>
tab (07) facing up from the rear of the phone. Ensure
that the contacts on the top end of the battery align
with the contact points (08) inside the battery
compartment.
V E R T U
0 4
0 5
0 6
0 8
0 8
0 1 G E T T I N G S T A R T E D
1-2
Advertisement
Table of Contents
