California Faucets Solimar CF-TO-V7002-9 Installation Instructions

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure:
Maximum Flow Rate:
Operating pressures between hot and cold supplies should vary no more than 30 psi.
*
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
†
1

INSTALLING SPOUT TO IN-WALL VALVE


Prior to installing faucet trim in-wall vessel rough
VALVE (1), CF-VL-R, must be properly installed
and wall surface must be completely finished

Recommended through-hole size shall be Ø1-1/4"

Apply thread sealant to both threaded ends of
NIPPLE (2), not supplied, and tighten into center
outlet of VALVE (1)

Securely tighten QUICK CONNECT (3) onto end
of NIPPLE (2) using I/2" open-end wrench

Place O-RING (4) into ESCUTCHEON (5) & slide
ESCUTCHEON (5) onto QUICK CONNECT (3)
IMPORTANT: To prevent damage to internal o-ring on SPOUT
(6), QUICK CONNECT (3) MUST be free of any dirt and/or debris

Slide SPOUT (6) onto QUICK CONNECT (3),
align ESCUTCHEON (5) & SPOUT (6) and tighten
SETSCREW (7) on bottom side of SPOUT (6)
CF-TO-V7002-9_ii_160720
Solimar
CF-TO-V7002-9
In-Wall Vessel Lavatory Faucet
Installation Instructions
BY A LICENSED PROFESSIONAL
20 to 70 psi
1.2 gpm
™
*†
Ø1-1/4"
(3 holes)
Pg 1