9. Alle vier Haltewinkel (9) wie abgebildet am Unterbau (1) der Hebebühne befestigen (Abb. 10.5).
Connect the angles (7) with the main-part of the lift (1) as shown in Fig. 10.5.
Montageteile / Assembling-parts :
2 x M12x80 Schrauben / Bolts (19)
4 x B13 Unterlegscheiben klein / Small washers (27)
4 x M12 selbstsichernde Muttern / Self-locking screw-nuts (23)
19
27
9
1
Abb. / Fig. 10.5
10. Befestigungsbohrung mit Steinbohrer Ø16 (B: Nicht im
Lieferumfang enthalten) mindestens 120mm tief bohren
(Abb. 10.6).
Drill the fixing-hole with rock-drill Ø16 (B: Not included in the
scope of delivery) at least 120mm deep (Fig. 10.6).
22
42
17
Abb. / Fig. 10.7
Abb. / Fig. 10.8
Carry Twin 3.5
23
17
•
2 x M12x40 Schrauben / Bolts (20)
11. Mutter und Unterlegscheibe wie abgebildet
H
(Abb. 10.7) auf großen Ankerbolzen (17)
aufschrauben und mit Hammer (H) durch
Haltewinkelbohrung in den Boden
einschlagen (Abb. 10.8).
Screw the screw-nuts and washer on the big
anchor-pins (17) as pictured (fig. 10.7) and
knock it with an hammer (H) through the
holding-angle into the ground (Fig. 10.8).
23
27
Abb. / Fig. 10.6
Seite / Page 19
1
20
9
B