Weslo Pursuit 655s User Manual page 9

DIAGRAM OF THE CONSOLE
The console
offers six modes
that provide
instant exercise
feedback. Each
mode is dis-
played for five
seconds in a
repeating cycle.
The modes are
described below.
Pulse—This mode displays your heart rate
when the pulse sensor is used.
Calorie—This mode displays the approximate
number of calories you have burned.
Fat Calorie—This mode displays the approxi-
mate number of fat calories you have burned.
(See Burning Fat on page 10.)
Speed—This mode displays your pedalling
speed, in kilometres per hour.
Time—This mode displays the length of time
you have exercised.
Distance—This mode displays the total number
of kilometres you have pedalled during your
workout.
HOW TO OPERATE THE CONSOLE
1. To turn on the
power, press the
on/reset button
or simply begin
pedalling. When
the power is
turned on, the
entire display will appear for two seconds. The con-
sole will then be ready for operation.
All manuals and user guides at all-guides.com
9
2. When the power
is turned on, the
console will
begin displaying
all modes in a
repeating cycle
(except for the
pulse mode).
Flashing arrows will show which mode is currently
displayed.
3. To measure your
pulse, stop ped-
alling and place
your thumb on
the pulse sensor
as shown. The
pulse sensor is
pressure-activat-
ed—fully press it down. Do not press too hard, or
the circulation in your thumb will be restricted,
and your pulse will not be detected. Next, slightly
raise your thumb until the heart-shaped indicator in
the display flashes steadily. Hold your thumb at
this level. After 5 to 10 seconds, three dashes will
appear in the display and your pulse will then be
shown. Hold your thumb on the sensor for another
15 seconds for the most accurate reading. If the dis-
played pulse appears to be too high or too low, or if
your pulse is not displayed, lift your thumb off the
sensor and allow the display to reset. Press down
again on the sensor as described above.
Make sure that your thumb is positioned as shown,
and that you are applying the proper amount of pres-
sure to the pulse sensor. Try the sensor several
times until you become familiar with it.
4. To reset the display, press the on/reset button.
5. To turn off the power, simply wait for about six
minutes. Note: The console has an "auto-off"
feature. If the pedals are not moved and the con-
sole buttons are not pressed for six minutes, the
power will turn off automatically in order to con-
serve the batteries.
Arrow