Assembly - Weslo Pursuit 655s User Manual

ASSEMBLY

Place all parts of the PURSUIT 655s in a cleared area and remove the packing materials. Do not dispose of
the packing materials until assembly is completed.
Assembly requires the included allen wrench
adjustable wrenches
1. Identify the Front Stabiliser (17), which has Wheels
(25) on the ends.
Hold the Front Stabiliser (17) against the saddle on
the front of the Frame (15). Make sure that the
Front Stabiliser is turned so the square holes are
facing away from the saddle. Attach the Front
Stabiliser with two M10 x 70mm Carriage Bolts (30)
and two M10 Nylon Locknuts (31).
Attach the Rear Stabiliser (not shown) to the rear of
the Frame (15) in the same manner.
2. The Console (7) requires two 1,5V batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Open the battery cover
on the underside of the Console as shown. Press
two batteries into the battery compartment. Make
sure that the negative ends of the batteries
(marked "–") are touching the springs in the
battery compartment. Close the battery cover.
Insert the console wire through the Handlebar Post
(14). Connect the console wire to the Reed Switch
Wire (50). Attach the Console (7) to the Handlebar
Post with four M4 x 12mm Self-tapping Screws (4).
Carefully slide the Handlebar Post (14) onto the
Frame (15). Be careful to avoid pinching the
wires inside the Handlebar Post. Attach the
Handlebar Post with three M10 x 25mm Button
Screws (8) and three M10 Split Washers (41).
Attach the Knob Housing (12) to the Handlebar Post
with an M4 x 16mm Self-tapping Screw (9).
3. Attach the Handlebar (5) to the Handlebar Post (14)
with two M10 x 25mm Button Screws (8) and two
M10 Split Washers (41).
All manuals and user guides at all-guides.com
.
6
, a phillips screwdriver
1
17
30
25
7
2
Console
Wire
4
50
41
8
3
8
41
5
and two
25
31
15
7 Batteries
Battery Cover
12
9
14
15
8
41
8
14