Yealink SIP T42G Manual page 44

All manuals and user guides at all-guides.com
User Guide SIP-T42G IP Phone
Headset Activation/Deactivation
To activate the headset mode:
1. Press on the phone.
The HEADSET key LED illuminates solid green when the headset mode is activated.
Press the line key or the Answer soft key to answer a call, the call will connect to
your headset automatically. Enter the desired number and then press the Send soft
key, the phone will place the call by using the headset automatically. For more
information about using the headset to place a call, refer to
51.
To deactivate the headset mode:
1. Press again on the phone.
The HEADSET key LED turns off when the headset mode is deactivated.
Headset Prior
You can use headset in priority when enabling the headset prior feature. This feature is
especially useful for permanent or full-time headset users.
To enable headset prior via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Headset Prior.
3. Click Confirm to accept the change.
To use headset prior, you should activate the headset mode in advance:
1. Physically connect the headset.
2. Press to activate the headset mode.
Note
If the headset prior feature is enabled, the headset mode will not be deactivated until
you press the HEADSET key again.
Dual Headset
You can use two headsets when enabling the dual headset feature. To use this feature,
you must physically connect headsets to the headset jack and handset jack
respectively. Once the phone joins in a call, people with the headset connected to the
headset jack has a full-duplex conversation, another people with the headset
connected to the handset jack is only allowed to listen to.
To enable dual headset via web user interface:
1. Click on Features->General Information.
36
Placing Calls on page