ZALMAN HD160XT PLUS Manual page 11

4) LCD and Card Reader PCB Cables
① Connect the D-SUB (RGB) Cable to the system' s (VGA or motherboard) D-SUB
(RGB) Port.
② Connect the Dual USB Cable that is connected to the USB Cable of the LCD and Card
Reader PCB to the motherboard' s USB Port.
③ Connect the System Power Switch Cable (2-Pin) with the motherboard' s Front Panel
Port (Refer to the motherboard manual).
④ Connect the Standby Power Cable (20-Pin or 24-Pin) to the motherboard and power
supply.
CAUTION)
If the individual USB connectors of the LCD and
Card Reader PCB get disconnected from the Dual
USB Cable, the VCC (red) wires MUST be aligned
when reconnecting the individual USB connectors
of the LCD and Card Reader PCB to the Dual USB
Cable. Incorrect alignment will cause a short circuit,
damage the components, and can be a fire hazard.
The design and specifications of this product may change without prior notice to enhance its quality.
All manuals and user guides at all-guides.com
HD160XT Plus
M/B
PSU
Red
Red
11