Advertisement
3
Install the exterior keypad
A
What is the diameter of the hole in the door?
Diameter is 2-1/8"
(54 mm)
2-1/8"
54 mm
Adapter Ring is required
for installation. Install on
Exterior Assembly.
B
Locate the screws for step 3D and keep them within reach.
48654
(2x)
C
Remove the mounting plate from the interior assembly.
4
Install the interior assembly
A
Ensure the turnpiece shaft is pointing up, and remove the interior cover and
battery pack from the interior assembly.
a
Remove the interior
cover from the
interior assembly.
c
If the turnpiece shaft is pointing
down, place the cover back onto
the interior assembly and rotate the
turnpiece until you hear it click. You
may need to apply some force.
Once the turnpiece shaft is correctly
oriented, remove the cover again.
D
Diameter is 1-1/2"
(38 mm)
or
1-1/2"
38 mm
Adapter Ring is not
needed for installation
and may be discarded.
b
Make sure turn
piece shaft is
rotated as shown.
Incorrect:
If turnpiece shaft is not oriented
correctly, put the cover back on and
rotate the turnpiece as shown in step C.
d
Do not install
batteries
until step 5.
Install the exterior keypad and mounting plate.
a
The cable goes
underneath the latch.
c
Keep parallel to the
edge of the door.
48654
(2x)
Tighten screws
evenly. DO NOT over
tighten screws.
B
Install the interior assembly onto the mounting plate.
a
Ensure tight cable
connection.
align
c
2 / 4
For
Lock
Bag
(2x)
48654
b
Support the exterior
assembly during mounting
plate installation.
G
Route the cable
through the center
hole, then push it into
the bottom hole.
d
Insert the key and
test the latch. If the
latch does not
extend or
retract
smoothly, adjust
the screws.
Remove the key
when finished,
and make sure
the latch bolt is
fully extended.
For
Lock
Bag
b
Lay the excess cable
flat inside the bottom of
the interior housing.
d
49191
(2x)
bottom
hole
Ensure you are using
the correct screws.
Using incorrect
screws will damage
the product.
actual size
(2x)
49191
actual size
Advertisement
