Table of Contents
Advertisement
Setting an indoor unit address and installation option
• The first digit represents the page number and the remaining five digits are installation option.
NOTE
• The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4) Press the
/
button to set the installation option code in order. Press
SEG1
SEG2
0
2
SEG7
SEG8
1
Drain pump
SEG13
SEG14
2
External control
SEG19
SEG20
Individual control of a
3
remote controller
5)
Press the
button to save and complete the option setting.
6) Press the
button to exit to normal mode.
• Press
button anytime during setup to exit without setting.
NOTE
• Option code will not be applied if you don't press
• Setting Installation option code is available only with a master wired remote controller.
• Setting Installation option code is available when there is one on one connection between a wired
remote controller and an indoor unit.
28
SEG3
External room
temperature sensor
/ Minimizing fan
--
operation when
thermostat is off
SEG9
Hot water heater
SEG15
External control
output / External
S-Plasma ion
heater On or Off
signal
SEG21
Heating setting
compensation
EEV Step of stopped
/ Removing
unit during oil return/
condensated water in
defrost mode
heating mode
button to go to the next page.
SEG4
SEG5
Central control
SEG10
SEG11
EEV Step when
--
heating stops
SEG16
SEG17
Buzzer
SEG22
SEG23
Motion detect sensor
button.
SEG6
FAN RPM
compensation
SEG12
--
SEG18
Number of hours
using filter
SEG24
--
Advertisement
Table of Contents
