Table of Contents
Advertisement
Setting an indoor unit address and installation option
Set the indoor unit address and installation option with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit address and installation option.
Setting an indoor unit address
1) Press the
and
displayed.
2) Press the
/
button to select
3) Press the
/
button to select and then press
Data bit
1 2 3 4 5 6
• The Main/RMC Address which is currently setting will flicker.
NOTE
• Data bit 1 and 2 present Indoor unit main address checking
• Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
• Data bit 5 and 6 present Indoor unit RMC address setting/checking.
4) Press the
/
button to set the Indoor unit Main/RMC Address.
5) Press the
button to save and complete the option setting.
6) Press the
button to exit to normal mode.
• Press the
button anytime during setup to exit without setting.
NOTE
• Address will not be applied if you don't press
• Setting Main/RMC Address of an Indoor unit is available only with a master wired remote controller.
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow
the directions below.
1) Press the
and
displayed.
2) Press the
/
button to select
3) Press the
/
button to select
code setting screen.
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
and then press
button to enter a Sub-menu setting screen.
button to enter a Indoor Address setting screen.
button.
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option
27
Advertisement
Table of Contents
